ECKELMANN UA 410 L Case Controller, Инструкция по эксплуатации

Страница: 57 / 92

Pin and Terminal Assignments of UA 410 L
51 Firmware V1.50 - Doku 2.0 06. April 2016
If 230 V AC voltage is present at digital input, the associated red LED lights,
see chapter 5.5.1 Status LEDs for details.
6.6 Terminal assignment of the 0..10 V analogue outputs
This functionality is currently not used!
Warning - hazardous electrical voltage!
Connecting mains power to the analogue outputs will lead
to the destruction of the controller!
Malfunctions due to interference sources: All leads running to and from the case controller must
be shielded (cable type: LiYCY)! No shielding is required on sensor leads when installed exclusively
inside the refrigerated display case and when external interference (for example from parallel power
wires) is not to be expected (see operating instruction “Basics and General Safety and Connection
Instructions”). As a general rule, care should be taken to ensure that signal leads and leads carrying
a supply voltage are routed through separate cable channels.
ZNG:112 830 DEF1
0..10 V
10 1
D32 D31 D22 D21 D12 D11
73 74 43 44 63 64 53 54
2 1 3 4
CAN-GND
CAN-LOW
CAN-HIGH
SHIELD
D42 D41
GND
AO2
GND
AO1
5
0
2
3
1
4 6
7
8
9
5
0
2
3
1
4 6
7
8
9
CAN-BUS
ADDRESS
1..99
V V
+ +
- -
AO1 AO2
PE (SHLD)
31 32 30 29
Controller
Type Terminal No. Analogue output 2 Analogue output 1
All controllers 32 GND --
31 AO2 (+ 0..10 V) --
30 -- GND
29 -- AO1 (+ 0..10 V)