ECI MOVFR, Руководство по установке

Страница: 11 / 27

ECI MOVFR-LCD Installation Manual
Electronic Controls, Inc.
7073 North Atlantic Ave. Cape Canaveral, FL 32920
800-633-9788
www.eciamerica.com P a g e | 11
•
SSO – Slow Start Open. Speed setting is OP slow start . When illuminated indicates the start of
the open cycle when the interlock rollers unlock hoistway door. SSO/FSO sensor blocked and
MSO sensor open during an OPEN cycle.
•
HSO – High Speed Open. Speed setting is OP High Speed. When illuminated indicates High
speed open. SSO/FSO and MSO sensors open during an OPEN cycle.
•
MSO – Medium Speed Open. Speed setting is OP medium sp. When Illuminated indicates
Medium Speed open. SSO/FSO sensor open and MSO sensor blocked during an OPEN cycle.
•
FSO – Final Speed Open. Speed setting is OP final speed. Illuminated during Final speed open
when SSO/FSO and MSO sensors are blocked during an OPEN cycle.
•
HOLDING – Illuminated when DCL or DOL sensors are blocked (fully OPEN or CLOSED
positions) and CL/OP hold torq and hold sp parameter settings are greater than 0
•
NUDGE – Nudge speed . Speed setting is Nudge . Illuminated when CLOSE and NUDGE inputs
are active.
•
HSC – High Speed Close. Speed setting is CL high speed . Illuminated during High speed close
when FSC sensor is open during a CLOSE.
•
FSC – Final Close Speed. Speed setting is CL final speed . Illuminated during final close speed
when FSO sensor is blocked during a CLOSE.
•
AUX – Illuminated when AUX sensor is blocked
•
DPM – Illuminated when DPM sensor is blocked
•
DOL – Door Open Limit. Illuminated when DOL sensor blocked
•
DCL – Door Close Limit. Illuminated when DCL sensor is blocked
•
STALL REVERSE – Not used
•
FREQUENCY FAILURE -
•
REOPEN DEVICE – Illuminated when the REOPEN relay is energized via the light curtain
inputs.
•
FAULT – Illuminated when there is a communications failure between Control and Drive boards
•
POWER – Illuminated when power to board is good.
5.1.3.3 Keypad
• +
Button - This button moves the curser up in the screen for selecting menus or parameters and
increases the number of the setting being programmed
• -
Button - This button moves the curser down in the screen for selecting menus and decreases the
number of the setting being programmed
•
Enter Button - The ENTER button selects the menu or parameter indicated by the curser and
enters the current number of the parameter being programmed.
•
ESC Button - The ESC button is used to move back to the previous menu
5.1.3.4 Switches
•
RUN / CAM SETUP – 2 position switch. RUN position is for normal operation. CAM SETUP
allows for adjusting CAMs with valid inputs to OPEN, CLOSE etc. without moving the doors.