Echowell Opal-100, Руководство пользователя

Страница: 5 / 13


Pulsports-100/200

Pulsports-100/200
E8- -E9
6. Maximum range for countdown is 99H59M59S.
7.
a). Press T.MODE to select “ TIMER ” mode.
Countdown timer setting:
b). Press SET for 2 seconds to enter timer.
c). Press T.MODE or ST/SP to set timer On or Off.
d).
Adjust the Timer data according to the Data Setting Processes.
1. Press ST/SP to change alarm set (1 to 3).
Alarm mode
2. The ” “ symbol will display after alarm setup.
3. The alarm is a 30 seconds beep, the ” “ symbol will blink.
4. Stop the beep by pressing any key.
5. Take note of the time mode you have selected 12H or 24H.
6.
a). Press T.MODE to select “ ALARM ” mode.
Alarm setting:
b). Press SET for 2 seconds to enter alarm setting mode.
c). Press T.MODE or ST/SP to set timer On or Off.
d). Refer the
Data Setting Processes
e). Press ST/SP to enter next alarm setting.
to adjust the Alarm data.
f). Repeat steps b-d to set the other alarm.
1. Calendar from the year 2000 to 2099.
Date mode
2. Day of week will display automatically while the date is input.
3.
a). Press T.MODE to select “ DATE ” mode.
Date setting:
b). Press SET for 2 seconds to enter data setting mode.
c). Refer the
Data Setting Processes to adjust the Date data.
1. Press ST/SP to start/stop chronometer.
Chronometer mode
2. Press T.MODE for 2 seconds to reset chronometer data.
3. Maximum range is 99H59M59S.
HEART RATE FUNCTION
DESCRIPTION
1. Start / Stop heart rate measure function
1. Press P.MODE for 2 seconds to start heart rate measurement
function.
2. When the function is operating, the LCD will display the signal as
“ ” and “
”.
3. Press P.MODE for 2 seconds to stop heart rate measurement
function.
4. If a signal is not received for 5 minutes, the function will turn off
automatically.
2. Start / Stop heart rate data record function
1. Press ST/SP to start heart rate measure function.
2. Press P.MODE to switch to EXE_TM function.
3. Press ST/SP, the signal shown as ”
” at the top right of the
display will change to “ “, and this means the data record
function is started. Stop by pressing ST/SP, the signal will change
to “
“.