EchoStar DVR-5000 HDD Viaccess, Дополнительное руководство

Страница: 9 / 52

Installation
Section 3
EchoStar International Corporation
Page 3 - 3
© 2
002 E
choS
tar
Inte
rnati
onal
C
o
rp
orat
io
n
A
ll ri
gh
ts
re
se
rv
ed
3
F
OR MOTORIZED CONFIGURATIONS
- A
UTOSAT
29. When in the Position field:
a. press and hold the or key and watch the
signal indicator for an indication;
b. in the signal indicator, make sure a network
name is shown;
c. press the key to select another transponder for
signal verification;
d. press the key to select the Position field;
e. use the key to fine tune for the best signal
level and quality;
f. press the OK key, note that the saved position of
the satellite is shown.
30. If you want to add your own defined transponder for
the selected satellite, go to the TP field and select
TP00 (Goes to the menu where you can define your
own transponder, for detailed information, refer to
section 6). If not proceed with step 36.
31. Go to the Search channels field.
32. On the RCU, press the OK key to advance.
33. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the search completed popup menu appears.
34. On the RCU, press the OK key. to end the initial
setup procedure.
CAUTION
On the motorized dish, set the physical East and West limit switches first. Failing to
do so might cause damage to your motorized dish installation or other properties.
21. Make the required selections.
22. Set the required installation mode, recommended
setting is Easy (guided setup procedure).
23. Read the available help text for information.
Note that only the white fields are selectable, other
fields show reference information.
24. Go to the Autosat field.
25. On the RCU, press the OK key to advance.