EchoStar DSB-890 2Ci, Руководство пользователя

Страница: 30 / 48

Description and Operation
Page 2 - 16 EchoStar International Corporation
© 2004
E
c
h
o
S
tar I
n
tern
ati
ona
l C
o
rpor
ati
o
n
A
ll ri
ght
s r
e
ser
v
ed
Installation setup Factory reset
1. User settings It is advised to write down the most important settings before you confirm the Factory reset
(e.g. Switch and Port settings, LNBs, User preferences, etc.).
If you select Yes, the receiver is ready to do a Factory reset.
Confirm If you select Confirm, the receiver deletes all user defined settings, channels, timers and
(favorite) lists and replace them with the factory defaults. If a Factory reset is done after a
Software upgrade, the latest satellite and transponder database is activated.
When the Factory reset is completed, the receiver shows the initial installation procedure as if
the receiver came out of the box.
Installation setup About EchoStar
This menu shows all the relevant company, receiver and EchoNAV Xpress information.
Installation setup Set limits
(motorized only)
CAUTION
On a motorized dish, set the physical East and West limit switches first. Failing to do so might
cause damage to your motorized dish installation or other properties.
1. EL Set the (software controlled) maximum dish position (East limit).
Green: to delete the current El and WL.
2. WL Set the (software controlled) maximum dish position (West limit).
Green: to delete the current El and WL.
3. My longitude (USALS only); Set the longitude for the installation site of the dish, you can obtain your
longitude from Stab at: www.usals.info.
Yellow: If a USALS mount is out of position, you can re-calibrate the position of the dish with
the command: Go to 0. Allow the dish some time to re-calibrate and return to the SAT.
4. My latitude (USALS only); Set the longitude for the installation site of the dish, you can obtain your latitude
from Stab at: www.usals.info.
Yellow: If a USALS mount is out of position, you can re-calibrate the position of the dish with
the command: Go to 0. Allow the dish some time to re-calibrate and return to the SAT.