EchoStar DISH Pro Plus Twin LNBF, Руководство по установке

Страница: 16 / 25

Page 13
Select Check Switch or Switch and then select either Check or Test to run Check Switch .
When the Check Switch procedure finishes, you should see a summary screen similar to one
of those shown in Figures 9 and 10.
• The summary screen in Figure 9 is similar to what should be shown for DISH Pro
and DISH Pro Plus receivers connected to the DISH Pro Plus Twin LNBF. Make
sure the summary screen shows reception from 110W and 119W satellites and the
third satellite location on all available satellite tuners. If not, consult your receiver
user's guide to re-peak your dish antenna as needed. Also confirm the LNBF is
correctly identified as a DP Plus Twin.
Figure 9. DISH Pro Plus Installation Summary
• The summary screen in Figure 10 is similar to what should be shown for a Legacy
receivers connected to the DISH Pro Plus Twin LNBF. Make sure the summary
screen shows reception from 110W and 119W satellites and the third satellite
location on all available satellite tuners. If not, consult your receiver user's guide
to re-peak the dish antenna as needed. Note that the DP Plus Twin will be
identified as SW64. This is OK and does not indicate a problem.
Note : Legacy receiver models 1000, 2000, 3000, 4000, 5000, 7100, 7200 and
JVC DVHS (HMDSR100U) cannot receive signals and will not detect from DISH
Network bandstacked FSS LNBFs.
Figure 10. Legacy Installation Summary