6
Installation Guide
6
tel - 1-800-477-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
EMUBCAMKIT
Universal Quad View Camera Kit
Camera/Video Interface Layout
1 2 3 4 5
ON
Yellow- Connect to Co12V
Red - Connect to Sw12V
Black - Connect to Ground (-)
Pink - Camera 4 Trigger (+)
Orange - Camera 3 Trigger (+)
Green - Camera 2 Trigger (+)
White - Camera 1 Trigger (+)
8-Pin Power/Trigger Plug
Remote IR Receiver
Camera Triggers 1-4
Display Mode Switch
Micro SD Card Slot
DIP Switches
Required for DVR Recording.
128GB Max Card Size
Switches between cameras
and display modes.
When +12V is applied, displays
corresponding camera.
Receives signal from the
wireless remote control.
Camera Inputs 1-4
Video Outputs
One of outputs (AHD or CVBS) will
connect to the AVS21 or directly
to the monitor source.
Display Triggers
Used to switch (trigger) the monitor to
camera source if manual camera activation
is not available on the monitor source.
DIP switches 1-4
correspond to Cameras 1-4
When in the OFF(DOWN) postion, the camera image will be normal (Non-Mirrored).
Non-Mirrored should be used for any forward facing cameras.
When in the ON (UP) postion, the camera image will reversed (Mirrored).
Mirrored should be used for any rear facing cameras.
DIP switch 5
sets Video Output Signal Type: Analog High Definition AHD 30fps,
AHD 25fps, NTSC, PAL. See page 15 for setting video output.
Front
Cam1
Left
Cam2
Rear
Cam3
Right
Cam4
Video-Out
