background image

6

the LED indicators. When the amber LED is blinking, go to step 3.

3. Press and hold the test button again for 6 seconds to select Range 

Confirmation Test.

All three LED’s will blink on and off (for 1 second) in this test mode, then if the 

sensor receives a range confirmation telegram, the sensor displays the linked 

signal strength status for 2.5 seconds, see table below.

LED

Signal Strength

Green - blinking 2.5 sec

-41 to -70 dBm

Amber - blinking 2.5 sec

-70 to -80 dBm

Red - blinking 2.5 sec

-80 to -95 dBm

No LED

No linked receivers detected

The test will repeat every 10 seconds and run for a duration of 50 seconds. You 

may quit the test at any time by pressing the test button for 6 seconds.

Commissioning  Test  Mode:

  This  mode  accelerates  the  time  period  between 

transmissions of the current light level to every 10 seconds, for a duration of 

5 minutes (regardless of amount of energy stored - See “Daylight Harvesting” 

above). This test requires a start assist battery to be installed for the duration of 

the test.

1. To enter Commissioning Test Mode, press and hold the teach button until 

the green LED begins to blink (about 6 seconds).

2. A quick press and release of the button at this point will allow you to select 

between test modes. Pressing and releasing the test button scrolls through 

the LED indicators. When the red LED is blinking, go to step 3.

3. Press and hold the test button again for 6 seconds to select Commissioning  

Test Mode.

You may quit the test at any time by pressing the test button for 6 seconds.

Содержание TAP-21C









Отзывы: