5
Indicator LED’s
Three LEDs (red, yellow and green) are located behind the PIR lens of the
sensor.
During normal operation the red LED will blink when the sensor is sending an
occupied telegram.
The LEDs are also used during the selection of the test modes and to indicate
status information.
See the Test Mode section for more details.
Linking Process
:
The linking process requires the controller or receiver to be mounted, powered
and within range of the OWS to be linked. Each Echoflex controller can support
up to 20 linked devices. Linking the OWS occupancy sensor and the OWS switch
will consume 2 of the receivers available linked devices. The controllers blink
code will indicate the number and type of objects linked and can be checked to
confirm the linking process completed successfully (Consult the manufacturer’s
controller/receiver install guide for more information).
Linking the Wireless Switch
1. Place the receiver into LEARN mode by pressing the Learn button on the
receiver. Consult the manufacturers directions if needed.
2.
Quickly click the top side of the switch rocker 3 times.
3.
Deactivate LEARN mode at the receiver. Test operation of the switch by
switching ON and OFF.
Note: Repeating these steps will UN-Learn the switch from the controller.
Linking the Wireless Occupancy Sensor
1.
Remove the OWS faceplate.
2.
Place the receiver into LEARN mode by pressing the Learn button on the
receiver. Consult the manufacturers directions if needed.
3.
Tap the Teach button (right of the PIR lens).
4.
Deactivate LEARN mode at the receiver.
Note: Repeating these steps will UN-Learn the sensor from the controller.
5
