Chapter 5. The use of ECHOSOFT software
5.6 Audiometry on ECHOSOFT
5.5.1
Update the device
AUDI
O
SCHOOL
If your
AUDI
O
SCHOOL
is connected in USB mode to
your computer, when the
ECH
O
SOFT
software starts
up, a check of the device's firmware version is launched.
If a more recent version is available, the software will
automatically offer to update. Click
"Yes"
to start
downloading the new version. When the new version
for your device has been downloaded, a pop-up window
will indicate that
"The update was successful"
. Re-
start the device and follow the information on the screen
to complete the installation
5.6
Audiometry on
ECH
O
SOFT
The
ECH
O
SOFT
software allows you to use the
AUDI
O
SCHOOL
as a peripheral device to perform tests from your
computer (PC or Mac) in manual mode. This allows you to control the device and view the curves and results.
Start the
ECH
O
SOFT
software, the window below will open. Connect the device to your computer and click on the
USB
button on the Home screen of your device. After connection, the
Audiometry
button becomes available above the
list of subjects, otherwise check if the driver has been correctly installed. If the subject already exists in the database,
simply select it. If not, it is possible to create a new one (see
). Select the subject, then click on the
Audiometry
test
button.
Select the doctor or operator who is performing the
measure. If the operator already exists in the database,
simply select it. If not, you can create a new one.
for instructions on the necessary equipment and patient set up
in order to install the ECHOSOFT software and the drivers necessary to carry
out measurements.
In order to optimize the battery charge of your
AUDIOSCHOOL
, the screen will turn off after 2 minutes
when the USB mode is activated and the device is connected to a computer. To turn the screen back on,
click the On/Off button.