![background image](http://html1.mh-extra.com/html/echo/tc-210aa/tc-210aa_operators-manual_3960798035.webp)
TC-210
MAINTENANCE
X7504083611
35
© 3/2018 ECHO Inc.
ENGLISH
2.
Start engine and run for several
minutes to reach operating
temperature.
3.
Stop engine. Turn HI (A) speed
needle CCW (counter
clockwise) to stop. Turn LO (B)
speed needle midway between
full CCW and CW (clockwise)
stops.
4.
Idle Speed Adjustment
Start engine and turn idle speed adjustment screw (C), CW until the tines
begin to turn, then turn the screw CCW until tines stop turning. Turn
screw CCW an additional 1/4 turn.
5.
Accelerate to full throttle for 2-3 seconds to clear excess fuel from
engine then return to idle. Accelerate to full throttle to check for smooth
transition from idle to full throttle. If engine hesitates, turn LO (B)
needle CCW an additional 1/8 turn and repeat acceleration. Continue
adjusting until smooth acceleration results.
6.
Check HI (A) speed RPM at W.O.T. (Wide Open Throttle). HI speed
RPM should be set to specifications found on "Specifications" page of
this manual.
7.
Check idle speed and reset if necessary. If a tachometer is available,
idle speed should be set to the specification found on "Specifications"
page of this manual.
When carburetor adjustment is completed, the cutting
attachment should not move at idle, otherwise serious personal
injury may result.
Lubrication
Level 1.
Parts Required:
Lithium Base Grease.
C
A
B