24
A
A
lubrIcatIon
Level
1.
Tools Required:
8 & 13mm Open End Wrench, Screwdriver, Clean
Rag, Grease Gun
Parts Required:
POWER BLENDX
TM
8 oz. (P/N 91014) or Lithium
Base Grease.
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease.
3. Add grease if necessary. DO NOT over-fill.
Drive Shaft
(SRM-265 Only)
1. Loosen two (2) screws (B) and remove center locating screw (C).
Pull gear box and shield from drive shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and
re-coat with a thin coating [15 ml (1/2 oz.)] of grease.
3. Slide the flexible cable back in the drive housing. DO NOT get
dirt on the flex cable.
4. Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
(SRM-265S Only)
No Lubrication Needed.
B
C
B
D
Содержание SRM-265
Страница 33: ...Grass Trimmer Brush Cutter 33 Operator s Manual notes ...
Страница 34: ...34 notes ...
Страница 35: ...Grass Trimmer Brush Cutter 35 Operator s Manual notes ...