16
HARNESS
CLAMP
INSTALLATION
NOTE
Some models require installation of Harness Clamp. If your unit
does not have a clamp, follow these directions.
Tools Required:
Screwdriver, 8 x 10mm Open End Wrench.
Parts Required
: Harness Clamp, 4 x 18mm Hexagon Head Bolt, Link,
Spacer.
6.
Remove shield and gear housing as an assembly.
a. Loosen two (2) screws that clamp the gear housing to the
drive shaft housing.
b. Remove locating screw found at the top of the gear housing.
Pull shield and gear housing assembly from the drive shaft
assembly.
IMPORTANT
Prevent flexible drive cable from sliding from drive shaft housing.
If cable does slide free, clean dirt from cable and re-lubricate with
lithium based grease prior to re-assembly.
7.
Remove front handle.
a. Remove four (4) screws and nuts and handle support from
handle.
b. Remove front handle.
8.
Install clamp.
a. Slightly spread clamp and slide up shaft.
b. Install single link using spacer, DO NOT tighten at this time.
9.
Install gear housing, shield and front handle.
10. Balance unit.
a. Put on harness and attach unit to harness.
b. Slide harness clamp up or down until unit balances with line
head approximately 2" - 3" from the ground.
c. Tighten harness clamp screw.
