Echo SHC-2100, Руководство оператора

Страница: 12 / 26

12
O
PERATION
STARTING COLD ENGINE
WARNING DANGER
Blades should not move at idle. If blades move, readjust carbure-
tor according to Carburetor Adjustment instructions in the
manual or see your ECHO dealer, otherwise serious personal
injury may result.
NOTE
Refer to the Hedge Clipper Safety Manual for proper and safe
hedge clipping operation.
1. Stop Switch - Start/Run.
Move Stop Switch button away from the STOP position.
2. Close Choke - Cold Start.
Move choke (B) to "Cold Start" position.
3. Primer - Pump Bulb.
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
WARNING DANGER
Inspect starting area for hazards such as rocks, glass, debris etc.
which could be contacted by the cutting blades when starting.
Keep helpers and bystanders at least 15 M (50 ft.) from starting
area, otherwise serious personal injury may result.
4. Starting
Lay the unit on a flat, clear area. Firmly grasp throttle grip with left
hand and fully depress throttle trigger to wide open position.
Rapidly pull starter handle/rope (D) until engine fires (or maximum
five (5) pulls.
5. After engine fires or five (5) pulls, move choke lever back to
"RUN" position. Hold throttle trigger fully depressed and pull
starter handle/rope until engine starts and runs. Release throttle
trigger and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in "RUN" position after 5 pulls,
repeat instructions.
6. After engine warm up, gradually depress throttle trigger to
increase engine RPM to operating speed.
B
C
D
A