![background image](http://html1.mh-extra.com/html/echo/pro-attachment-pas-225vp/pro-attachment-pas-225vp_operators-manual_3932358030.webp)
OPERATION
PAS-225/SB/VP/VPB
30
X7732274006
© 09/21 ECHO Incorporated
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using unit
again.
Applications
Do Not install blades on GT (Curved Shaft) trimmers.
Operating Techniques - Nylon Line Head
Nylon line heads may be used for trimming, scything, edging, and scalping
of grass and light weeds.
Trimming
Feed the spinning line into the material to be cut. Tilt the line head to one
side to direct cutting debris away from you:
• Model SRM/DSRM/PAS/SB/TX/C/T (Straight shaft, counter-clockwise line
head rotation) - Tilt the cutting head down on the right side (muffler side)
while cutting to direct cutting debris away from operator. Feed the line
gradually into the material you wish to cut, avoiding contact with fences or
other barriers.
• GT models: Tilt cutting head to the left while cutting to direct debris away
from the operator.
Scything
Scything - Swing the cutting head in a level arc, gradually feeding the line
into the material being cut. Move forward with each arc to cut a swath.
Width of cutting swath depends on arc. Use a larger arc for a wider swath,
or a smaller arc for a narrow swath. Keep line head tilted to direct cutting
debris forward or away from you.
Edging and Scalping
Both of these are done with the nylon line cutting head tilted at a steep
angle. Scalping is removing top growth, leaving the earth bare. Edging is
trimming the grass back where it has spread over a pavement or driveway.
During both edging and scalping, hold the unit at a steep angle in a position
where the debris, and any dislodged dirt and stone, will not come back
towards you even if it ricochets off the hard surface.