![background image](http://html1.mh-extra.com/html/echo/power-pruner-ppt-2400/power-pruner-ppt-2400_operators-manual_3994375011.webp)
P
ower
P
runer
™
o
Perator's
M
anual
11
1.
oPERAToR'S mANUAL
- Read and understand this manual before operation. Keep manual in a safe location for
future reference, i.e., operation, maintenance, storage and specifications.
2.
PoWER HEAd
- Includes the Engine, Clutch, Fuel System, Ignition System and Starter.
3.
REAR HANdLE ASSEmbLy
- Sturdy handle for right hand placement. Includes stop switch and throttle trigger.
4.
THRoTTLE TRIGGER LoCKoUT
- This lever must be depressed before throttle trigger can be operated.
5.
THRoTTLE TRIGGER
- Spring loaded to return to idle when released. During acceleration press trigger gradu-
ally for best operating technique.
6.
SToP SWITCH
- Mounted on top of handle assembly. Move switch forward to run, back to stop.
7.
LoWER SHAFT TUbE
- Durable fiberglass mesh housing.
8.
AUTomATIC oILER ASSEmbLy
- Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.
9.
SAW CHAIN
- 90 SG 9.53 mm low profile Oregon® saw chain. Runs approximately 610 m/min at full throttle.
10.
GUIdE bAR
- 305 mm guide bar.
11.
CUTTING SHoE
- Used to capture and stabilize branch while cutting. Place cutting shoe against branch, acceler
-
ate and lower saw chain into branch.
12.
CUTTING ATTACHmENT
- Sealed, gear ratio is 1.5 : 1 reduction.
13.
ARm REST
- Provides arm rest during operation and protects arm from hot engine.
14.
mUFFLER, SPARK ARRESTER
- The muffler controls the exhaust noise while the spark arrester prevents hot,
glowing particles of carbon from leaving the muffler where they could possibly start a fire.
15.
RECoIL STARTER
- Pull recoil handle slowly until starter engages, then quickly and firmly. When engine starts
return handle slowly.
do NoT
let handle snap back or damage will occur.
16.
FUEL TANK
- Contains fuel and fuel filter.
17.
FUEL TANK CAP
- For closing the fuel tank.
18.
CHoKE
- Located above air cleaner housing. Controls operation of choke. Move lever to start position (Close
Choke) and back to run position (Open Choke).
19.
PURGE bULb
- Pump purge bulb until fuel is visible and flows freely in the “Clear” fuel return line. Pump bulb an
addition 4 or 5 times.
20.
AIR CLEANER ASSEmbLy
- Contains replaceable air filter element.
21.
SPARK PLUG
- Provides spark to ignite fuel mixture.
22.
GUIdE bAR CoVER
- Used to cover guide bar and saw chain during transport and storage. Remove guide bar
cover before using unit.
23.
SHoULdER HARNESS
- An adjustable strap that suspends the unit from the operator.
Содержание Power Pruner PPT-2400
Страница 29: ...Power Pruner Operator s Manual 29 NOTES ...
Страница 30: ...30 NOTES ...
Страница 31: ...Power Pruner Operator s Manual 31 NOTES ...