![background image](http://html.mh-extra.com/html/echo/power-blend-csg-680/power-blend-csg-680_operators-manual_532550013.webp)
13
CSG-680
How to Install the Wheel
Insert the bar tool.
Rotate the drive shaft until the hole in the large pulley and the bar tool
aligned.
Unscrew wheel mounting bolt with the 17 mm end of the box wrench or your
fingers.
Remove wheel bolt, washers and outer flange, leaving inner flange in place.
Mount wheel on arbor between the two flanges.
Install flat washer, lock washer and wheel bolt.
Tighten bolt securely.
WARNING
z
Before tightening, check that flanges are properly seated and not
cocked on the mount or bolt threads. Do not make bolt so tight as
to destroy the cushion supplied by the wheel blotters. Never fasten
while applying your weight. Otherwise the thread could be broken.
Do not tighten more than 20 N•m (200 kgf•cm).
z
Inner and outer flanges are not interchangeable. Reversing
positions may cause wheel damage and lock the wheel.
NOTE
Arm may be removed and remounted with wheel on the outboard side of
the arm as required for certain procedures. See page 18 for details.
Remove Wheel Bolt,
Washers and Outer
Flange
Bar Tool
Wheel Bolt
Hole the Large Pulley
Wheel with Blotters
Lock Washer
Flat Washer
Arm
Outer Flange
Inner Flange
22 mm Adapter
Cutting Wheel
Box Wrench 17×19 mm
Tighten