![background image](http://html1.mh-extra.com/html/echo/pb-411/pb-411_operators-manual_4059143015.webp)
15
P
OWER
B
LOWER
O
PERATOR
'
S
M
ANUAL
OPERATION
- Provide all operators of this equipment with the Operator's Manual
and instructions for safe operation.
- Check unit for loose nuts, bolts and screws daily.
- Recoil starter: Use short pulls - only 1/2 - 2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the unit
firmly.
- Rotate spring loaded throttle handle downward to a comfortable
operating position.
STARTING
COLD
ENGINE
1. Turn switch to "RUN" position.
2. Close choke (move choke lever down) and pull recoil starter
handle until engine fires.
3. Open choke and if necessary, restart engine.
NOTE
Allow engine to warm up before use.
STARTING
WARM
ENGINE
1. Turn switch to "RUN" position.
2. Move throttle lever to start/idle position, pull recoil starter handle
5 times and engine should start. Do not use choke.
NOTE
If engine does not start after 4 pulls, use cold start procedures.
STOPPING
ENGINE
1. Move throttle lever to idle position and allow engine to run at idle
for a few minutes.
2. Move switch to "STOP" position.
WARNING DANGER
If engine does not stop, move choke lever to closed position to stall
engine. Check and repair stop switch before starting engine again or
serious personal injury may result.
Open choke
Close choke
Recoil starter handle
Choke lever
RUN
STOP
Idling
High speed
START