13
Maintenance and care
Maintenance and care
Servicing guidelines
Maintenance and care
Blade replacemnt/lubrication
Gear case
1. Turn off the engine.
2. Remove split pin (A).
3. Rotate blade until holes in inner blade adapter (B) and gear
box align. Insert locking tool to lock PTO shaft (C).
4. Remove blade nut (D) in a clockwise direction using
scrench. Remove outer blade adapter (E), blade (F) and in-
ner blade adapter (B).
5. Remove plug (G) and fill gear case with grease. Install plug.
6. Install inner blade adapter (B) onto PTO shaft (C).
7. Install and center new blade (F) onto inner adapter (B).
8. Install outer adapter (E) and nut (D). Tighten nut (D) firmly,
anticlockwise.
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings. Always stop engine, disconnect the spark plug wire, and make sure all moving parts have come to a com-
plete stop before removing obstructions, clearing debris, or servicing unit. Allow unit to cool before performing service.
Wear gloves to protect hands from sharp edges and hot surfaces.
Area
Maintenance
Frequency
Drive shaft
Grease
Every 25 hours of use
Gear Housing
Grease
Every 15-25 hours of use
Screws, bolts and nuts
Inspect, Tighten/Replace
Before each use
If you have any questions or problems, please contact your dealer.
NOTE
Grease gear case every 15 - 25 hours of use. Replace blade
when it is worn shorter than 6 in. Remove blade and holders
before greasing to prevent damage to gear and bearings.
NOTE
Shield cover not shown for illustration clarity.
NOTE
Blade nut (D) is left hand thread.
Содержание MTA-LE/E
Страница 2: ......
Страница 56: ...18 1Notizen und hintere Umschlagseite NOTIZEN...
Страница 57: ...19 NOTIZEN...
Страница 95: ......