Echo MegaLoop, Руководство пользователя

Страница: 5 / 12

Installation Instructions
(Refer to Fig. 1 – Fig. 4)
:
1. Place the MegaLoop
TM
amplifier on top of your TV, Video
Recorder or on a shelf. Make sure there is a power socket
available for the mains power adapter.
2. Plug the MegaLoop TM mains power adapter (B) into a standard
electrical power socket, then plug the power lead into socket (8) (Fig. 2).
3. Starting from the amplifier, run the loop wire (C) around the edge
of the room. The wire can be tacked up and over door frames if
necessary. The wire can be tucked under the carpet or clipped to
the skirting board (Fig. 3). Make sure you leave enough wire to
reach the amplifier.
4. Once a complete loop of the room has been formed, cut away
any surplus wire making sure to cut away the insulation from the
wire ends. Clip each end of the wire into terminals (9) (Fig. 2).
5. If you are using a loop pad (Optional), clip the end of the lead into
terminals (9) (Fig. 2). Make sure the lead is placed carefully, so
as not to cause a tripping hazard. Never run the lead across the
floor unless fully under the carpet. Always remember that loose
wires are a tripping hazard.
6. If your TV has audio output sockets connect the phono/phono
lead (G)to these sockets and plug the other end into the line input
on the MegaLoop Fig 2 (10).
If your TV has no audio output sockets but has a spare scart
socket, connect the scart plug (F) into the TV and connect the
phono/phono lead (G) to the scart, then plug the other end of the
lead into the MegaLoop audio input Sockets fig 2 (10).
If the SCART connection is not successful, connect the
microphone. Simply plug the3.5 mm jack on the microphone lead
into the microphone socket on the MegaLoop fig 2(12) and fix the
microphone onto the TV speaker using the Velcro fig 4.
7. With the power switched on at the wall socket press the Power
Button (7) ON and the Power “ON” Light (6) will give a constant
Green light (Fig. 1).
3