![background image](http://html1.mh-extra.com/html/echo/hc-155-20/hc-155-20_operators-manual_4016720006.webp)
6
equIpment
check
WARNING
Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment com-
bination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which
have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and
safety manual.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
• Check that the cutting attachment is firmly attached and in safe operating condition.
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings.
•
ALWAyS
stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
•
DO NOT
start or operate unit unless all guards and protective covers are properly assembled to unit.
•
NEVER
reach into any opening while the engine is running. Moving parts may not be visible through openings.
WARNING
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found,
do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho-
rized servicing dealer before using.
An Emission Control Label
is located on the engine.
(This is an EXAMPLE ONLY, information on label varies
by engine FAMILY).
e
mIssIon
c
ontrol
(
exhaust
&
evaporatIve
)
EPA 2010 and Later and/or C.A.R.B. TIER III
PRODUCT EMISSION DURAbILITy (EMISSION COMPLIANCE PERIOD)
The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine
emissions output meets applicable emissions regulations, provided that approved maintenance procedures are fol-
lowed as listed in the Maintenance Section of this manual.
The emission control system for the engine is EM (engine
modification) and, if the second to last character of the
Engine Family on the Emission Control Information label
(sample below) is “C”, “K”, or “T”, the emission control
system is EM and TWC (3-way catalyst). The fuel tank/fuel
line emission control system is EVAP (evaporative emis-
sions). Evaporative emissions for California models are only
applicable to fuel tanks.
Содержание HC-155-20
Страница 30: ...30 notes ...
Страница 31: ...Hedge Clipper Operator s Manual 31 notes ...