16
Operation
Starting the cold engine
∗
Starter handle
1. Ignition switch.
2. Throttle trigger lockout.
3. Throttle trigger.
4. Choke lever.
5. Purge bulb.
6. Fuel return line.
Before starting engine make sure cutting attachment is not in touch with ground or other
objects.
Place ignition switch in the "start" position.
Push purge bulb until fuel is visible in clear fuel return line.
Move choke lever to close (
) position.
Pull starter handle until first firing sound.
Open (
) choke.
Restart engine and allow to warm up.
Starting the warm engine
Place ignition switch in the "start" position.
Move choke lever to open (
) position.
If tank is not empty, pull starter handle.
If fuel tank is empty, after refilling, push the purge bulb (until fuel is visible in clear fuel return
line).
Pull starter handle.
Stopping the engine
1. Throttle trigger.
2. Ignition switch.
Release throttle trigger and allow engine to idle.
Place ignition switch in the "STOP" position.
3. Spark plug cap.
4. Spark plug.
Always disconnect the spark plug cap (ignition cable) from the spark plug to ensure the engine
cannot be started before you work on the unit or leave it unattended.
WARNING
When engine starts, the cutting attachment may rotate, even with throttle trigger in
low-speed position.
When engine is started, confirm if there is not any abnormal vibration or sound.
If there is abnormal vibration or sound, ask your dealer to repair.
NOTE
Check unit for loose nuts, bolts and screws before starting.
Always clear work area of debris before starting operation.
Always hold the unit firmly on the ground.
When pulling starter handle, use short pulls, 1/2 to 2/3 of rope length.
Do not allow the starter handle to snap back against the housing.
NOTE
If engine does not start after 4 pulls, use cold starting procedure.
WARNING
If engine does not stop, close choke to stall engine.
Have your ECHO dealer inspect and repair ignition switch before using the unit.
