![background image](http://html1.mh-extra.com/html/echo/gt-200/gt-200_operators-manual_4049507010.webp)
10
A
B
MIN
SPACING
FRONT
(
LOOP
)
HANDLE
NOTE
Label shows minimum spacing for front handle location.
NOTE
Front handle is pre-installed. Re-positioning and tightening is all
that is required.
1. Position front handle (A) in comfortable operating position and
tighten wing nut (B). The cutting attachment should be 5-7.5 cm
(2-3 in.) above the ground and as level as possible.
NYLON
LINE
HEAD
INSTALLATION
1. Align locating hole in upper plate with hole in bearing housing.
2. Insert locking tool (D) and thread cutting attachment onto shaft
clockwise until head is tight.
IMPORTANT
Remember to remove the locking tool.
O
PERATION
NOTICE: Use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor
performance, or severe engine damage and void the product warranty. Read and follow instructions in the Storage
section of this manual.
FUEL
WARNING
DANGER
Alternative fuels, such as E-20 (20% ethanol), E-85 (85% ethanol) or any fuels not meeting ECHO requirements are
NOT approved for use in ECHO 2-stroke gasoline engines. Use of alternative fuels may cause performance prob-
lems, loss of power, overheating, fuel vapor lock, and unintended machine operation, including, but not limited to,
improper clutch engagement. Alternative fuels may also cause premature deterioration of fuel lines, gaskets,
carburetors and other engine components.