![background image](http://html1.mh-extra.com/html/echo/ccs-58v4ah/ccs-58v4ah_operators-manual_3904040019.webp)
English
19
Fig. 15
HINGE
2 in. OR 1/10 DIA
NOTCH -
APPROX. 1/3
DIAMETER OF
TRUNK
BACK CUT
2 in.
Fig. 16
NOTCH
BACK CUT
Fig. 17
HINGE
45°
45°
PLANNED LINE
OF FALL
RETREA
T P
ATH
RETREA
T P
ATH
OPERATION
If the tree starts to fall in the wrong direction,
or if the saw gets caught or hung up during the
fall, leave the saw and save yourself!
Felling a tree - When bucking and felling op-
erations are being performed by two or more
persons, at the same time, the felling operation
should be separated from the bucking operation
by a distance of at least twice the height of the
tree being felled. Trees should not be felled in a
manner that would endanger any person, strike
any utility line or cause any property damage. If
the tree does make contact with any utility line, the
utility company should be notified immediately.
Before any cuts are started, pick your escape
route (or routes in case the intended route is
blocked); clear the immediate area around the
tree and make sure there are no obstructions in
your planned path of retreat. Clear paths of safe
retreat should extend back and diagonally (45°)
to the rear of the planned line of fall. When the
tree begins to fall, you should retreat away from
the direction of fall along a retreat path and at
least 20 feet away from the trunk in case it kicks
back over the stump.
See Figure 15.
Before felling is started, consider the force and
direction of the wind, the lean and balance of
the tree, and the location of large limbs. These
things influence the direction in which the tree
will fall. Do not try to fell a tree along a line dif-
ferent from its natural line of fall.
The chain saw operator should keep on the
uphill side of the terrain as the tree is likely to
roll or slide downhill after it is felled.
Remove dirt, stones, loose bark, nails, staples,
and wire from the tree where felling cuts are to
be made.
Notched Undercut.
Cut a notch about 1/3 the
diameter of the tree, perpendicular to the direc-
tion of fall. Make the cuts of the notch so they
intersect at a right angle to the line of fall. This
notch should be cleaned out to leave a straight
line. To keep the weight of the wood off the saw,
always make the lower cut of the notch before
the upper cut.
See Figure 16.
Felling Backcut.
The backcut is always made
level and horizontal, and at a minimum of 2 in.
above the horizontal cut of the notch.
See Fig-
ures 16 - 17.
Содержание CCS-58V4AH
Страница 31: ...English 31 NOTES NOTAS...
Страница 61: ...Fran ais 32 NOTES...
Страница 91: ...Espa ol 32 NOTAS...