Technical Specifications:
14
Power Supply
12v DC. 3.0 amp positive centre
Output
Output Current > 4amp peak current
into 0.4ohms
Frequency Response 100Hz to 5.0khz
Tone Control Effect +/-3db range @200Hz and 5KHz
Microphone
2 microphone inputs 3.5mm mono/
electret condenser
Line Input 2 line-level input, 3.5mm stereo
connector with gain control
Digital Input
1 line-level optical input, Toslink
connector with gain control
Digital Input
Coaxial input
AGC
>30dB range
Dimensions
190mm (W) x 45mm (H) x 112mm (D)
Weight
441 grams
Line Audio input
Nominal level 100mV
Microphone P input Nominal level -60dB
Microphone 1 input Nominal level -44dB (Background
noise switch low) -50dB (High)
Loop output impedence Between 0.4ohm and 1.0 ohm
Loop wire recommended for areas covered, according to
BS EN 60118-4-2006
16sqm to 40 sqm – 0.75mm csa –
BS. EN 60118-4-2006
40sqm to 65 sqm – 1mm csa –
BS. EN 60118-4-2006
65sqm to 90 sqm – 1.5mm csa –
BS. EN 60118-4-2006
NOTE:
Capable of meeting BS. EN 60118-4:2006 for a loop area not
exceeding an area of 90 sqm (9.5m x 9.5m) A larger loop area
can be used if a lower signal strength is acceptable which will
depend greatly on your hearing aids or receiver.
Coverage is dependent on the specific installation. Irregular
shaped areas, proximity to large metal structures, positioning
of the loop cable etc will affect the field strength.
