2
6.
Remove two (2) bottom T27 Fan Cover Protector screws, and one
(1) drive housing clamping screw. Remove orange outer Fan Cover
Protector. Remove ignition wires from gray Fan Cover.
7. Remove upper right and upper left T27 screws from gray Fan Cover
and remove Fan Cover from engine.
8. Remove Main Pipe Holder retaining ring using external snap ring
pliers.
9. Spray WD-40 around top of rubber anti-vibe mount. Use a flat head
screwdriver and carefully pry the rubber away from the Fan Cover
wall, allowing the WD-40 to penetrate and loosen the seal between
the rubber and Fan Cover.
10. Use a flat blade screwdriver to gently pry the Main Pipe Holder from
the Fan Cover.
NOTE:
DO NOT USE EXCESSIVE FORCE otherwise the holder and
Fan Cover may be damaged.
11. Use cupped pliers to complete removal of the Main Pipe Holder from
the Fan Cover.
12. Remove the Clutch Drum Snap Ring using external snap ring pliers
equipped with .053 tip.
