ECHO BARRIER H-SERIES, Руководство пользователя, Страница: 22 / 24

PAGE 22 — ECHO BARRIER • USER MANUAL — REV. #0 (09/14/18)
CLEANING
Figure 16. Cleaning the Panels
A B C D
CLEANING INSTRUCTIONS
1. Hang the Echo Barrier panel on a fence (Figure 16 A),
with the back (mesh side) facing towards you.
2. Pressure-wash the mesh from top to bottom.
3. If necessary, scrub the mesh using warm soapy water
and a stiff brush. Pressure-wash the mesh again to
remove soap and residue.
4. Using a wet vac with a squeegee attachment (Kaercher
or similar), remove surface water from the mesh.
5. Reverse the Echo Barrier panel and hang it with the
front (green side) facing towards you. See Figure 16
B.
6. Pressure-wash the surface dirt from the front of the
panel (Figure 16
B).
7. Scrub the front of the panel with warm soapy water
and a stiff brush (Figure 16 C).
8. Pressure-wash the front of the panel to remove soap
and residue.
9. Using the wet vac, remove surface water from the front
of the panel (Figure 16
D), so that the panel is dry to
the touch.
NOTICE
If surface water is not removed from the panel prior to
stacking, it is possible that the panel will not look clean
once it has dried.
GRAFFITI REMOVAL
1. Lay the Echo Barrier panel flat.
2. Pour Rapid Remover into a spray bottle, spray the
affected area and leave for one minute.
3. Using a dry cloth, wipe the affected area. This will
remove 60–80% of the graffiti.
4. To remove the remaining graffiti, apply some Rapid
Remover to a dry cloth/sponge and scrub the graffiti.
5. Once all the graffiti is removed, clean the panel
(following the instructions in the previous section), in
order to wash away all traces of Rapid Remover.