8
CHUTE DIRECTIONAL CONTROL
The chute directional control is located on the panel of
the snow blower. To change the direction in which
snow is thrown, turn the control as follows:
• Crank it clockwise to discharge to the right.
• Crank counterclockwise to discharge to the left.
A – Discharge Chute Rotation (Left/Right)
1.
Press the chute rotation switch to the UP
position and hold it there to rotate the chute
to the left.
2.
Press the switch to the DOWN position and
hold it to rotate the chute to the right.
3.
After reaching the desired position, release
the switch back to the CENTER position to
turn it off.
B – Chute Deflector (Up/Down)
1.
Press the chute deflector switch to the UP
position and hold it there to provide a higher
stream of snow and for a greater distance.
2.
Press the switch to the DOWN position and
hold it there to provide a lower stream and for
less distance.
3.
After reaching the desired position, release
the switch back to the CENTER position to
turn it off.
CLEAN-OUT TOOL
WARNING: Never use your hands to clear a
clogged chute assembly. Shut off the engine and
stay behind its handles until all moving parts have
stopped before you unclog or attempt to unclog
the chute.
The chute clean-out tool is fastened to the top of the
auger housing with a mounting clip. The tool is
designed to clear a clogged chute assembly.
NOTE
: This item (along with the electric starter’s
extension cord) is fastened with a cable tie to the rear
of the auger housing at the factory. Cut the cable tie
before operating the snow blower.
SKID SHOES
Position the skid shoes based on surface conditions.
Adjust them upward for hard-packed snow. Adjust
them downward when operating on gravel or crushed
rock surfaces.
RECOIL STARTER HANDLE
This handle is used to start the engine.
AUGERS
When engaged, the augers rotate and draw snow into
the auger housing.
CHUTE ASSEMBLY
Snow drawn into the auger housing is discharged out
the chute assembly.
GAS CAP
Unscrew the gas cap to add gasoline to the fuel tank.
OIL FILL
Engine oil level can be checked and oil added through
the oil fill.
