GB
37
Always disconnect the power supply before any manipulation with the device in order to prevent electric
shock.
WARNING
Never operate the heater without an attached base.
Installation requirements
Place the convector on a flat surface with a sufficient amount of space around the appliance to ensure the
proper function of exhaust vents.
There must be a distance of at least 30 cm between the device and the surrounding objects.
WARNING
To prevent the device from overheating, do not cover the heater.
The heater must not be placed directly under an outlet.
The surfaces marked this way become hot during use.
DO NOT COVER!
WARNING
Some parts of this product may become very hot and cause burns. It is necessary
to exercise extra caution in the presence of children or persons with impairments.
Installing supports
1. Turn the convector upside down.
2. Attach the base so that the holes in a convector line up with the holes in the
base.
3. Tighten the screws carefully and check if the convector is stable.
USING THE APPLIANCE
Note: When first switched on or switched on after a long period of inactivity, the heaters may emit odor or
smoke. This is normal and will fade away in a short while.
This convector uses convection heating technology with temperature control. It is also equipped with the
function TURBO (use of heating together with a fan) Thermostat control (A) is used to regulate temperature.
Turn the power control to set the required level: You can use the function TURBO to heat the room faster.
With the power control (B) you can set:
2 power levels:
I
= 1200 W
II
= 2000 W
2 power levels using the fan (TURBO):
= 1200 W
= 2000 W