GB
40
3. Tighten the stirrup properly with the wing nut so that the appliance is stable and there is no risk its
overturning (Figure 4).
4. Repeat the procedure with the second base on the other side of the radiator.
WARNING:
Place the “U” shaped base right behind the control panel and the second one between the last two
ribs – see the photos in the description.
USING THE APPLIANCE
Note:
An odour or smoke may emit from the heat elements during the first use of the appliance or when
turning on after a longer period of time. This effect is normal and will go away after a short while.
Main switch and power level settings
0
= Radiator is off
I
= 500 W
II
= 1000 W
II
= 1500 W
Thermostat and temperature settings
When you turn the thermostat control
8
you can regulate the temperature.
When the ambient temperature reaches the desired temperature, slowly rotate the thermostat until you hear
“snap”. Be careful not to continue turning. The thermostat will follow this set temperature and will continue to
maintain it.
Turning off the radiator
First, set the thermostat control
8
in the “MIN” position and the power level control
7
to “0” position. Then
always unplug the power cable from the outlet.
Note:
Any handling of the appliance can be performed only if it is turned off with the main power switch and
unplugged from the outlet.
Protection against overheating
The internal heat fuse protects the radiator against overheating and switches off the appliance automatically.
In this case, the operating lamp will switch off.
If the appliance switches itself off, unplug the power cable from the socket. After cooling down (about
15 minutes), the appliance is again ready for use. Plug the power cable back into the socket.
If the situation persists, first make sure the thermostat controller is properly configured and whether the air
vents are not covered.
CLEANING AND MAINTENANCE
Always unplug the power cord from the outlet before cleaning and wait for the appliance to cool completely.
Clean the outer surface of the radiator with a damp cloth. Do not use sharp or abrasive agents to clean the
device, otherwise the surface of the radiator can become damaged.