31
EN
Automatic and manual reception
The device starts automatic reception always at 1:00, 2:00 and 3:00. If the device does not succeed in receiving
the DCF time signal at 3:00, it will try the reception again at 4:00. In case of another failure, it will try at 5:00. If
it fails again to receive the signal, it automatically starts receiving again at 1:00 the following day.
Manual signal reception:
Simply press and hold
/
WAVE
. The device beeps briefl y and starts manual
reception. Press and hold
/
WAVE
to stop DCF reception.
When receiving the time signal, the buttons of the device do not work and no measurements of temperature
and humidity is carried on. The display shows the original temperature and relative humidity. The actual
temperature and humidity will show again on the display after about 30 minutes.
Cancelling the DCF signal reception
Press and hold two buttons in the same time for 2 seconds
/
WAVE
and
/
12/24
. The device beeps briefl y
twice and the radio control function is permanently disabled.
If you want to renew the radio control function, hold two buttons
/
WAVE
and
/
12/24
for 2 seconds. The
device beeps briefl y twice and the DCF function restarts immediately.
TIME DISPLAY IN THE 12H OR 24H FORMAT
Press
/
12/24
to switch between 12HR and 24HR time display mode. If you select 12HR mode, the display
will show in the afternoon
PM
symbol on the left.
SETTING TIME
1. Hold
the
SET
button for 2 seconds, the numbers on the clock start fl ashing. Using
/
set hour.
2. Press
again
SET
, the minute numbers start fl ashing. Using
/
set minutes.
3. Then
press
SET
once again. The display shows 00. Using
/
select the time zone.
“00” = GMT +1 hour (i.e. Czech Republic)
“01” = GMT +2 hours (i.e. Finland)
“-01” = GMT 00 (i.e. Great Britain)
4. Press
SET
to return to regular mode. When you will not press any button within about 8 seconds the
device will return to regular mode automatically.
SETTING ALARM
1.
Press and hold the
AL 1-2 SET
button. The time starts fl ashing together with the alarm clock symbol.
Using
/
set the desired wake up time.
2. Press
again
AL 1-2 SET
to save the alarm clock setup and to return to regular time display. When you
will not press any button within about 8 seconds the device will return to regular mode automatically.
ALARM CLOCK TURN ON AND OFF
Press the
AL 1-2 ON-OFF
to switch on or off alarm clock 1 or 2. When the alarm clock function is on, on the
display of regular time, there is a symbol
AL1
or
AL2
to the left of the time display.
