37
GB
3. Using the control button, set the temperature to required level in the range of 60–240 °C (10 stage
temperature control).
4) Setting the timer
-
when the power stage is set
1. Press the “Menu” button the third time, the power level indicator will light up and the timer control; the
display will show “0:00”.
2. Using the control button set the required time in the range of 0:01 – 3:00. The setting advances by
1 minute.
3. After setting the timer wait, until the display shows the preset power setting 1600 W. Then using the
control button set the required power level.
-
when the temperature is set
1. Press the “Menu” button the fourth time, the temperature level indicator will light up and the timer
control: the display will show “0:00”.
2. Using the control button set the required time in the range of 0:01 – 3:00. The setting advances by
1 minute.
3. After setting the timer wait, until the display shows the preset temperature 240 °C. Then, using control
button, set the required temperature.
5) Switching off
1. After you are fi nished cooking, switch off the induction hob by pressing the on/off button; the display
will show “OFF”. The fan will still run for a while to cool the appliance.
2. When the fan stops, disconnect the appliance from the power outlet and let it cool entirely.
CLEANING AND MAINTENANCE
Before cleaning and any handling of the induction hob, unplug it from the power outlet and allow the hob
to cool!
Keep the hob out of reach of children until it cools!
After cooling, clean the ceramic glass cooktop and the control panel of the hob with a cloth and use a cloth
moistened with dish detergent for more soiled places.
Do not use abrasive sponges or scouring powder. Do not immerse the induction hob and the power cord in
water!
Keep the top of the hob clean all the time to prevent accumulation of dirt around the fan and its possible
failure. Wipe the dust from the area of air circulation openings using cotton buds or a toothbrush with a small
amount of non agressive cleaning detergent and carefully remove oil stains.
Clean carefully the remnants of cleaning agents off the cooktop with damp cloth, otherwise they can burn
when the hob is turned on.
WARNINGS
If the display shows a warning message, follow the instructions below.
Warning code
Possible cause
Solution
EO
An unsuitable pot/pan is on the
induction zone or the diameter of the
pot/pan is less than 12 cm.
Place suitable cookware on the cooktop.
E1
Bad connection of the induction hob/
faulty electrical circuit.
Contact an authorized service center.
E2
Problem with the temperature sensor. Contact an authorized service center.
E3
Voltage is too high.
Check the power source, turn on when the
power source returns to normal.