English
English
21
IMPORTANT NOTE:
These values were obtained under laboratory conditions according to appropriate
standards. These values may vary depending on environmental conditions and use of
the dryer.
WARNING:
1. For safety reasons, regulations require an area of at least 1 m² per 8 g of refrigerant for this type of
equipment. For 110 g of propane, the minimum allowable room size would be 13.75 m³.
2. Coolant: Risk of fire / poisoning risk / risk of material damage and damage to the appliance. The appliance
contains coolant, R290, which is environmentally safe but flammable. Improper disposal may result in fire
or poisoning. Dispose of the appliance properly and take care not to damage the refrigerant circuit.
•
Type of coolant: R290
•
Amount of gas: 110 g
•
POD (Potential ozone depletion): 0
•
PGO (Global warming potential): 3
1. Risk of explosion and fire! Remove all lighters and matches from the pockets.
2. Do not place the dryer next to an open flame and sources of fire.
TROUBLESHOOTING
The dryer is equipped with systems that are continuously checking during drying to take the necessary
precautions and warn you of any malfunction.
WARNING:
If the problem persists even though you applied the steps provided in this section, contact your
vendor or an authorized service. Never try to repair a malfunctioning product.
PROBLEM
CAUSE
SOLUTION
The drying process takes a
long time.
The surface of the lint filter may be
clogged.
Wash the filter with lukewarm water.
The condenser may be clogged.
Clean the capacitor.
The ventilation grilles at the front of
the machine can be closed.
Open the doors/windows so that
the room temperature does not rise
too much.
There may be a layer of scale on the
humidity sensor.
Clean the humidity sensor.
The dryer may be overloaded with
laundry.
Do not overload the dryer.
The laundry may not be sufficiently
spun.
Select a higher spin speed on the
washing machine.
The laundry is damp at the
end of the drying process.
Laundry that is hot at the end of drying is usually wetter.
The programme used may not be
suitable for the type of laundry.
Check the care labels, select the
appropriate programme for the
type of laundry and use the time
programmes.
The surface of the lint filter may be
clogged.
Wash the filter with lukewarm water.
The condenser may be clogged.
Clean the capacitor.
The dryer may be overloaded with
laundry.
Do not overload the dryer.
The laundry may not be sufficiently
spun.
Select a higher spin speed on the
washing machine.
