24
EN
INSTALLATION
1. Remove each part from the packages. If the front and back screens are connected, separate these.
2. Remove the base and parts of the stand from the box and loosen the 4 attachment screws. Attach the
stand to the base using the attachment screws.
3. Dismantle the four position screws on the motor, place the back screen against the four holes on the
motor (handle facing upward), insert the four position screws into the holes and tighten these.
4. Loosen the nut screw on the propeller, place the propeller on the motor shaft and secure by tightening
the screw. Make sure the propeller does not interfere with the screen.
5. Install the front screen on to the back screen. Tighten the screw and nut, secure the retaining clips.
Nut
screw
Front
screen
Propeller
Back
screen
Rotation
control
Speed
control
Motor
Stand
Connector
Spring
Base
Supply
feed
Position
screw
HEAT PROTECTION
Heat protection is activated if an actuating unit is overloaded. The fan switches off automatically. In this case,
refer to a professional service centre.
USE
The fan has 3 speeds, its rotating head ensures smooth rotation. It is quiet, with a low energy consumption,
reliable and safe and at the same time, ensures eff ective air circulation.
