GB
48
Power connection
•
This appliance is designed for power supply 220~240V/50Hz.
•
The power cable of your washing machine is equipped with special plug with grounding
pin. This plug should be connected only to a grounded outlet in an outlet circuit with 10
A fuse. If you do not have such a 10 A fused outlet, ask a qualifi ed electrician to install one.
•
We are not liable for damages caused by use without proper grounding.
Note:
Using a low voltage for the appliance will result in reduced life and lower power.
Connecting the water supply
•
Your washing machine is equipped with a cold water inlet.
•
In order to prevent water leakage at the connection points, a bolt is supplied with the hose,
which must be attached to the water supply hose at the water tap.
•
Screw on the new water inlet hose onto the tap with thread ¾ inches.
•
Attach the white bent end of the supply hose to the white fi lter inlet on the back of the
washing machine. Tighten the plastic connecting nuts manually. If you are unsure about
the connection, entrust it to a qualifi ed installer.
•
The water pressure should be in the range 0,01~1,0 MPa. If the water pressure is higher,
install the pressure reducer into the line.
•
After installation fully open the tap and check for leaks at the connection points.
•
Make sure that the new supply hose is not bent, broken or pinched and that it has the
original length.
Note:
When connecting the washing machine, use only new supply hoses supplied
together with the washing machine. Never use old, used or damaged water hoses.
3/4”
10 mm
Connecting the drain hose
•
End of the drain hose can be attached to a special facility for
sewage drain or a special outlet on the sink siphon.
•
Never try to extend the length of the drain hose using clamps.
•
Make sure the drain hose is not folded, twisted, pinched, and has
the original length.
•
Fasten the drain hose to a height of 60 - 100 cm above the fl oor.
•
Do not put the drain hose into the sink, bucket or basin with no
outlet.
M
in. 60 cm
M
ax. 100 cm