GB
17
OPERATING INSTRUCTIONS
Start and operation
•
Before using the appliance for the fi rst time, switch on the refrigerator without food and allow it to stabilize.
That takes about 2 to 3 hours. Then set the thermostat control to the desired temperature and place the
food in the refrigerator.
•
You can set the temperature in the refrigerator using the thermostat control. For normal operation, it is
best to set the controller to a medium value.
•
Whenever a layer of ice forms with a thickness of 3 to 4 mm on the surface of the evaporator, defrost the
refrigerator, see "Defrosting" section.
Tips for proper use
•
Inserting larger quantities of food at one time, frequent door opening or long time open door leads to an
increase in electricity consumption.
•
Do not put in the refrigerator objects that are too heavy or sharp or aggressive materials.
•
To reduce moisture and subsequent ice build-up, never put liquid into the refrigerator in unsealed
containers. Frost tends to concentrate in the coolest parts of the evaporator. Storing of uncovered liquids
is the cause of the more frequent need for defrosting.
•
Never put warm foods in the refrigerator. These should fi rst cool down at room temperature and then be
placed so as to ensure adequate air circulation in the refrigerator.
•
Foods or food containers should not touch the back wall of the refrigerator, because they could freeze
to the wall. After disconnecting the refrigerator from the power supply wait at least 10 minutes before
plugging it in again.
•
In case of power failure, open the refrigerator as little as possible.
•
When defrosting, never use sharp or metallic objects to remove ice from the evaporator. You could damage
the evaporator.
Using the refrigerator at home
•
Try no to open the door too often, especially during hot and humid weather. When you open the door,
remember to close it as soon as possible.
•
Check from time to time if there is suffi
cient ventilation (adequate air circulation behind the appliance).
•
Under normal temperature condition at home set the thermostat to the medium value.
•
Before putting food in the refrigerator, let it cool fi rst to room temperature.
•
The layer of ice increases energy consumption, therefore defrost the refrigerator as soon as the ice layer
reaches a thickness of 3-5 mm.
•
If the refrigerator is equipped with an external cooler, the wall behind the refrigerator should always be
clean and free of dust and dirt.
•
Always keep in mind the instructions in the "Location" section. Otherwise, the refrigerator consumption
may increase signifi cantly.
CLEANING AND MAINTENANCE
•
Before you start cleaning the refrigerator, remove the power cord plug from the outlet.
•
Carefully wipe the refrigerator with a cloth soaked in a mild detergent solution. Do not use abrasive
cleaners, alkaline cleaners and alkalis, chemical wipes, thinner, alcohol, acids, gasoline cleaners, or hot
water. You could damage the surface fi nish and plastics.
•
The door seal is easily clogged, clean it regularly.
•
If you will not use the refrigerator for a long time, pull the plug out of the outlet, dry it and close the door
carefully.
•
Clean the condenser at the rear of the appliance at least once a year. You will increase effi
ciency and reduce
power consumption.
