English
English
8
How to remove residual water from the hose
If the connection to the drain pipe is located higher than 1000 mm, excess water may remain in the drain hose.
In this case, the residual water must be allowed to flow out of the hose into a bowl or other suitable container
located below the level of the sink.
Water drainage
Attach the drain hose. The drain hose must seal perfectly to prevent water leaking from the joint. Make sure
that the drain hose is not twisted or wrinkled.
Extension hose
If you need an extension drain hose, use a similar type. It must not be longer than 4 m, otherwise the
performance of the dishwasher will be reduced.
Water shut-off connection
The drain hose connection must be located 1000 mm (maximum) above the bottom of the dishwasher.
Placement of the dishwasher
Place the appliance in the desired location. The back should face the wall and the sides should face adjacent
cabinets or walls. The dishwasher is equipped with hoses for water supply and drainage, which can be
positioned on the right and left, thus allowing for an ideal installation.
Levelling the dishwasher
Once the dishwasher is in place, its height can be adjusted using the adjustment
bolts located at the bottom. The dishwasher must not be tilted by more than 2°.
Built-in installation
Choosing the best location for your dishwasher
The dishwasher should be installed close to the supply and drainage pipes and the electricity supply. Illustration
of cabinet dimensions and installation position of the dishwasher.
1. The built-in dimensions are given with a distance between the top of the dishwasher and the cabinet top
of less than 5 mm and with the door in the plane of the cabinets.
600 mm (for 60 cm model)
450 mm (for 45 cm model)
Electrical, drainage
and supply
connection
Space between the bottom of
the line and the floor
