110
EN
USB playback
Connecting a USB device.
1. On the front panel, open the compartment labelled
.
2. Insert a USB memory device into the USB slot. The system automatically begins to play from USB.
•
Note:
Make sure that the connected USB device contains
compatible music fi les.
Removing a USB device
Remember to switch off the stereo, before removing the USB device.
SD card playback
Inserting the memory card
1. Press the unlock button on the front panel.
2. Push the left side of the panel to the right and remove
the panel.
3. Insert the card correctly into the memory card slot. You
should hear a clicking sound.
4. Close the front panel. The system automatically begins to
play from the memory card.
Removing an SD card
Remove the front panel. Push on the card until you hear a
clicking sound. The card slides out slightly allowing you to
remove it.
Connecting an external player
Connect an external player to the stereo using the AUX IN connector on the front
panel. Press the MODE button to select AUX mode. Press the button again to cancel
AUX mode and return to the previous mode.
System reset
The stereo can be reset to its default settings.
•
The RESET button is located behind the front panel of the stereo (see fi gure). Use a sharp object like a pen
to push this button.
•
Perform a system reset in the following cases:
1. System initialization after installation and completing all wiring
connections.
2. The device does not react to any buttons being pressed.
3. An error message is shown on the display.