English
English
32
normal transmission rate values are the theoretical maximum for wireless standards. This is not an efficient
data transfer rate.
•
The locations where transmission is most effective vary depending on the user environment.
•
Wireless TV option supports modem type 802.11 a,b,g & n. The use of the IEEE 802.11n communication
protocol is strongly recommended to avoid potential problems when viewing video.
•
If modems with the same SSID are located nearby, you must change the SSID of one of them. Otherwise,
connection problems will occur.
Configure wireless device settings
You can start the connection process from the Network Settings menu, where you set the Connection
Method
to
Wireless Device
.
If you wish to search for available wireless networks, highlight
Search wireless networks
and press
OK
. A list
of all the networks found will appear. To connect to the network, select the desired network from the list and
press
OK
. A network with a hidden SSID cannot be discovered by other devices. To connect to a network with a
hidden SSID, scroll down the list of wireless networks you've found, highlight Add new network, and press
OK
.
Enter a network name and use the appropriate connection options to select the security type.
Note:
If the modem supports N mode, you can set it up.
If the selected network is password protected, enter the correct password using the virtual keyboard. Use the
directional buttons and the
OK
button on the remote control to use this keypad.
Wait until the IP address is displayed.
This means that the connection has been established. To disconnect from the wireless network, select
Connection method
and use the Left or Right button to set it to
Off
.
If you're connected to a wireless network, the Network menu will show Disconnect and your wireless network
profile will be saved, so your TV will connect to the same network automatically whenever you switch to a
wireless connection. To disconnect from the wireless network and delete the saved wireless network profile,
highlight Disconnect and press
OK
.
If your router has WPS, you can connect directly to the modem/router without entering a password or adding
a network first. Select WPS on your router and press
OK
. To connect, press the WPS button on your modem/
router. After the devices have connected, a confirmation message will appear on your TV. Select
OK
to continue.
No further setup is required.
Highlight
Connection speed test
and click
OK
to check the speed of your Internet connection. Highlight
Advanced Settings and click
OK
to open the Advanced Settings menu. Use the directional and numeric
buttons to adjust the settings. When you are done and want to save the settings, highlight Save and press
OK
.
More information
If a connection is established, the connection status is displayed as Connected or Not Connected and the
current IP address.
Connect your mobile device via WLAN
•
If your mobile device is WLAN-enabled, you can connect it to your TV via a router to access your device's
content. In this case, your mobile device must have the appropriate sharing software.
•
Follow the steps in the previous chapter to connect your TV to the router.
•
Then connect your mobile devices to the same router (same Wi-Fi network) and launch the selected UPnP/
DLNA casting app on your mobile device. Then select the files you want to share with your TV.
•
If the connection is established correctly, you should now be able to access shared files from your mobile
device via Audio Video Sharing, which is included with your TV.
•
Highlight
Audio and Video Sharing
in the Sources menu and press
OK
to see the available devices on the
network. Select your mobile device and press
OK
to continue.
•
If available, you can download the virtual remote control app from your mobile app provider's server.
Note:
This feature may not be supported on all mobile devices.
