ECG 20 H01T2S2, Инструкция по эксплуатации

Страница: 119 / 156

GB
119
INTRODUCTION
Thank you for purchasing this television� In order to use this device to its full potential from the very start, read
this manual carefully and keep for future use�
ATTENTION
Do not tamper with any internal components and do not make any adjustments that are not defined in this
manual� LED TVs use high voltage� When cleaning dust or drops off the display or device case, first unplug the
power cord from the socket and then wipe the device with a dry towel� To prevent damaging the TV, disconnect
the power cord and antenna during a thunderstorm� Contact a qualified service centre for all necessary repairs�
TV INSTALLATION AND CONNECTION
Instructions for assembling the stand
1� Open the cardboard box and remove the TV, accessories and
stand (only available with certain models)�
2� Place the device on a flat service with the screen facing down�
Use a blanket or other soft fabric to protect the display�
3� Slide the stand into the holder and firmly tighten with the
included screws�
4� The assembly is now finished�
Positioning
• Place the unit within the room so that the display is not exposed
to direct sunlight�
• Complete darkness or reflections on the screen can cause eye
fatigue� Soft indirect light is recommended for comfortable viewing�
• Leave enough space between the TV and wall to allow sufficient air
circulation�
• Stay away from excessively warm areas to prevent damaging the TV
frame or the premature ageing of components�
• Do not cover ventilation holes�
Antenna and power connection
1� Connect the antenna cable to the antenna connector on the back of
the TV�
2� Plug the power cord into the electric socket�
3� Switch the TV on�
Press the On/Off switch on the TV� The indicator will turn green� When
the TV is in standby mode (red indicator), the TV can be turned on by
pressing a button on the remote controller�