EN
G
LIS
H
20
Support:
Support.Eccotemp.com
Shop Online:
www.Eccotemp.com
NORMAL OPERATION
FREEZE PREVENTION
• Only the pipes and heat exchanger inside the
water heater will be protected.
• Any hot or cold water pipes located outside of the
unit will not be protected.
• Proper protection and insulation of these pipes
will be required to ensure these are protected from
freezing.
1) Turn on the power switch.
2) After confirming power is on, press the remote control power button “ ”
3) Open the inlet water valve and gas valves.
4) Open the water valve (hot water tap), the water
heater will ignite and work, and hot water will flow
out.
5) During the operation of the water heater, if the
power supply suddenly stops, the water heater will
stop working and close the gas valve. When the
power is reset, the water heater with the remote
control can be started by the remote control, and
the water heater without the remote control can be
started after re opening the water.
6) Power failure before operation, the water heater
cannot start to provide hot water service.
WARNING! If freezing conditions are expected, turn off water and gas and drain all water from
the appliance. If power and the automatic frost protection are connect
ed freezing will be
prevented.
NOTICE! When freezing temperatures persists consult with a licensed installation professional
for winterization of your product.
NOTICE! Eccotemp recommends
all termination hoods have a
backflow preventer to assist with
freezing
air. Consult with an installation professional for proper installation.
NOTICE! During power
outages built in freeze protection will not be activated.
Take proper steps
to ensure
your water heater doesn’t
freeze.