Ecco Pro Vantage 12+ Series, Инструкция по установке и эксплуатации

Страница: 20 / 20

Troubleshooting:
All lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the life of the product, follow the
guide below for troubleshooting and repair information. If the problem cannot be rectified using the solutions given below, additional information may be
obtained from the manufacturer – contact details are at the end of this document.
PROBLEM POSSIBLE CAUSE SOLUTION
Does not function
Poor power or ground connection
If controller functions normally, or if a 12/24V control voltage is present
on either the Pattern 1 (brown) or Pattern 2 (orange) wires, then replace
the driver board in the lightbar.
If controller does not function, then check fuse, cables, and connections
to the lightbar and to the controller.
Blown fuse Check wiring, replace fuse
One or two LED head do not flash,
but Pattern 1 or Pattern 2 indicator
LED on control module is on.
Open circuit wiring from control module to
LED head
Connect a known-good LED head to the problem output to ensure the
control module is working correctly. Repair or replace.
Failed LED head Replace LED head
LED head flashes dimly Defective head or driver board Check correct LED head
Incorrect flash patterns
Wrong flash configuration
Re-program the lightbar flash pattern for either Program 1 or Program 2,
or both.
Secondary pattern does not function Normal operation Primary function overrides secondary function – turn off primary function
LIGHTBAR AND CONTROLLER
PROBLEM POSSIBLE CAUSE SOLUTION
Light does not function
Defective light Replace light
Defective controller
If indicator LED on controller is lit, then it is either the light, or the
cable to the light, or the driver board. Otherwise the controller is
defective.
ALLEY / TAKEDOWN / WORKLIGHTS
PROBLEM POSSIBLE CAUSE SOLUTION
Both/all lights do not function
Blown fuse Check wiring, replace fuse
No power Check to see if vehicle S/T/T lights function properly
Failed S/T/T LED head
Make sure that the S/T/T head is plugged into the S/T/T control board
and not the driver board. Replace S/T/T LED head and/or its cable.
STOP/TAIL/TURN
Learn more about emergency and warning lighting we have.