Page 2 of 6
L-Bracket Mounting:
1. Mark drill hole locations on the mounting surface using the
short leg of the bracket as a template.
2. Drill mounting holes using a 3.74 mm drill bit. Drill a 10 mm
hole for routing the wires as needed.
3. Attach the bracket to the directional with the supplied
machine screws.
4. Mount the directional and bracket to the mounting surface,
routing the wires through the 10 mm hole using additional
grommets or cable protection as necessary to protect the
wiring from any sharp edges. Secure the directional to the
surface using the supplied thread forming screws. See
Figure 1.
Wiring Instructions:
Important!
This unit is a safety device and it must
be connected to its own separate, fused power point
to assure its continued operation should any other
electrical accessory fail.
Flash Pattern Selection:
The ED3779 series directionals can be configured to flash the
following patterns (in the order below) by momentarily applying
ground to the blue wire. The directional must be powered
through the ground and power wires to allow pattern selection.
The ED3779 Series of directional LED light heads are self
flashing. All wiring should be a minimum of 20 AWG. The
positive line must have an in-line 3 amp slow-blow fuse for each
directional as shown. Set each unit to the same flash pattern
before syncing. Synced units will flash simultaneously when set
to the same phase or alternating when set to A and B. Note:
Only flash patterns with an A or B phase identified are capable
of being synced. Isolate the yellow and blue wires when not in
use.
YELLOW -
(SYNC)
+
-
BLACK - GROUND
BLUE -
FLASH PATTERN
SELECT (MOMENTARY TO (-))
DIM (+)
RED - COLOR 1
SWITCH
(USER SUPPLIED)
IN-LINE FUSE
(USER SUPPLIED)
WHITE -
COLOR 2 (DUAL
COLOR ONLY)
SWITCH
(USER SUPPLIED)
SWITCH
(USER SUPPLIED)
ORANGE -
TAKDOWN
FIGURE 2
FIGURE 1