EC Printer EC80320, Руководство пользователя

Страница: 22 / 48

EC-80320 User’s Manual
- 20 -
3.3 HEX DUMP PRINTING
This function allows you to check whether the connection between the printer and the host or
terminal device works properly or not.
The method is that press FEED button and power on the printer, the ERROR indicator blinks once
with two beeps. Go on holding the button for about a second, loosen it after the ERROR blinks once
again with a beep. Turn off the printer when you want to exit this print mode.
3.4 Restoring Factory Printer Settings
The function is to clear the settings stored in the printer and restore the factory settings for
correlative parameters.
The method is that press FEED button and power on the printer, the ERROR indicator blinks once
with beeping twice at the same time. Do not loosen the button until the ERROR indicator blinks
twice with beeping twice in two seconds. At this time, turn off the printer and the function takes
effect.
3.5 Setting Slip Stitch
If needed, Slip Stitch is used to upgrade printer firmware or it should be closed in normal working
condition. When to upgrade, pull out the Slip Stitch Cap after the printer is turned off, press FEED
button and power on again, the ERROR and PAPER OUT indicator blinking once at the same time,
which indicates that the printer enters into the online-upgrade mode. Loosen the button and then
use the computer software equipped with the printer to upgrade. Turn off the printer after finishing
upgrading, plug Slip Stitch Cap and then the printer can be working normally.
Note: Do not change the Slip Stitch without any permission of the factory, or the printer can
not work.
3.6 Online-aptitude Parameter Settings
EC80320 supports the function of online-aptitude parameter settings, which can be set in the PC
with the driver installed in. The parameter settings of serial interface can be modified in the
driver’s property page.
The concrete setting steps are shown as follows:
1. Make sure that the host and the printer are connected with a cable and both the host and the
printer is turned on, the printer should be online as well.
2. Click “Start” Æ ”Settings” Æ ”Printers”
When plugging into
When pulling out
Slip Stitch Cap
Slip Stitch
Fig3-2 Setting slip stitch