Ebyte E43-900T13S3, Руководство пользователя

Страница: 20 / 26

Chengdu Ebyte Electronic Technology Co., Ltd. E43-900T13S3 User manual
Copyright ©2012–2019
，
Chengdu Ebyte Electronic Technology Co., Ltd.
19
spread on the Top Layer of the module contact part(All copper-covered and well grounded), and must be close to
the digital part of the module and routed in the Bottom Layer.

Assuming the module is soldered or placed in the Top Layer, it is also wrong to randomly route the Bottom Layer or
other layers, which will affect the module's spurs and receiving sensitivity to varying degrees.

Assuming that there are devices with large electromagnetic interference around the module, the performance of the
module will also be greatly affected. According to the intensity of the interference, it is suggested to stay away from
the module appropriately. If circumstances permit, appropriate isolation and shielding can be done.

Assume that there are traces with large electromagnetic interference around the module (high-frequency digital,
high-frequency analog, power trace), which will greatly affect the performance of the module. It is recommended to
stay away from the module according to the strength of the interference. If necessary, appropriate isolation and
shielding can be done;

If the communication line uses a 5V level, a 1k-5.1k resistor must be connected in series (not recommended, there is
still a risk of damage).

Try to stay away from some physical layers and also have a 2.4GHz TTL protocol, for example: USB3.0.

The antenna mounting structure has a great influence on the performance of the module. It is necessary to ensure
that the antenna is exposed, preferably vertically upward. When the module is mounted inside the case, use a good
antenna extension cable to extend the antenna to the outside of the case.

The antenna must not be installed inside the metal case, w
hi
ch will greatly reduce the transmission distance.
10. FAQ
10.1 Communication range is too short

The communication distance will be affected when obstacle exists.

Data lose rate will be affected by temperature, humidity and co-channel interference.

The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near ground.

Sea water has great ability in absorbing wireless radio wave, so performance will be poor when testing near the sea.

The signal will be affected when the antenna is near metal object or put in a metal case.

Power register was set incorrectly, air data rate is set as too high (the higher the air data rate, the shorter the
distance).

When the power supply at room temperature is lower than the recommended low voltage, the lower the voltage is,