CPX200NB ALARM CONTROL UNIT – USER MANUAL
11 / 30
EN
4.2.2.
Away mode
In order to arm the partition in the away mode, user has to input his code and
press the
button. Exit time countdown will start. Partition will arm in the
stay mode in the following cases:
1.
Partition has perimeter exit zones and at least one of them is violated
during the exit time countdown.
2.
Partition does not have any perimeter exit zones.
Correct code will be confirmed by the keypad by 3 beeps.
Leave the facility before the time for leaving expires. That state is indicated by
intermittent sound and quick flashing the ARMED LED on the keypad until the
system gets fully armed. If the chirps are activated the arming will be
confirmed by one chirp of siren.
4.3.
ARMING THE SYSTEM WITH FAULT
If during the arming any faults are present in the system, the keypad will indicate it
with flashing ARMED and SYSTEM LEDs and long constant audio signal. LEDs 1 to 8
will indicate which system errors are present. That state will maintain for 10 seconds.
If there is no possibility to quickly remove faults, press
to arm the system.
Pressing
will cancel the arming process.
Note: Remove the causes of faults as soon as possible.
Error codes:
1 – Damage or disruption of detector
2 – Damage of signalling device or signalling device active
3 – Damage of internal connection or sabotage
4 – AC power supply damage
5 – Battery damage
6 – ATS damage
8 – Other damages
