Ebotics Code & Drive, Руководство пользователя

Страница: 31 / 93

31
CODE & DRIVE MANUAL
7.1. Assemble the mounted piece A with the mounted piece C. Insert the line-follower sensor
cables through the horizontal-rectangular hole of the piece C.
7.2. Place piece A under piece C in a position that the holes of piece C are aligned with the
metallic spacers of piece A. Put a nylon spacer on a screw and tighten it with the metallic
spacer placed at the center of the piece C. Repeat this process with the other metallic
spacers placed in the middle of piece C.
7.3. Tighten a screw on each metallic spacer placed at the front side. Screw it through the light
sensor holes and the nylon spacer.
7.4. Once piece C and piece A are attached, tighten the motor screws. You can hold the nuts
with your fingers to tighten them comfortably.
STEP 8
8.1. Place piece D under the end of piece C in a position that the metallic spacers coincide with
the curved slots of the end of piece C.
8.2. Put a nylon spacer on a screw and insert the screw through the curved slot of piece C.
Tighten it to the metallic spacer of piece D. Have in mind that piece C and D have to be
aligned.
PIECES REQUIRED
X2
M3/12
Nylon
spacers M3
Mounted piece D
X2