31-7-2014 67 ebode IPV38P2P
Disable Start-Up:
When rebooting, the camera will not pan / tilt.
Go To Home Position: When rebooting, the camera will pa Providing Central Management
Software to manage or monitor multi-cameras n / tilt and stops at center.
Go To Preset Position:
Select one preset position and save it. When rebooting, the
camera will pan/ tilt and stops at the preset position you have set.
Figure 6.72
6.8 Firewall
This section explains how to control the access permission by checking the client PC’s IP
addresses. It is composed of the following columns:
Block access from these IP
addresses and Only allow access from these IP addresses.
Figure 6.73
Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP
addresses at most, only those clients whose IP addresses listed in the Only allow access
from these IP addresses can access the Network Camera. If you select Block access from
these IP addresses, only those clients whose IP addresses are in the IP list cannot access
the Network Camera.
Click Save to take effect.
