ebm-papst RV45-3/14, Руководство по эксплуатации

Страница: 6 / 7

page 6 of 7
7 FAULTS, POSSIBLE CAUSES AND REMEDIES
Replace your product by a new one, do not repair it.
DANGER
Electrical voltage at motor
Wait five minutes after the voltage
(all poles) has been switched off
before opening the product.
Fault/
Error
Possible cause Possible remedial
action
Mechanical
blocking Switch off, de-energize
and eliminate
mechanical blocking.
Mains voltage fault Check mains voltage,
re-connect voltage
supply.
Connection faulty Rectify connection, see
pin connection.
Motor is too hot Allow motor to cool /
identify cause of fault.
Motor winding
interrupted Exchange product.
Motor is not
rotating
Ambient
temperature too
high Reduce ambient
temperature if possible.
Impeller out of
true Unbalance of
rotating parts Clean product if still
unbalanced after
cleaning, exchange
product.
Note
If the device is not operated for a
lengthy period in installed condition in a
dry environment, it is to be started up
and operated at full speed for one hour
at least every four months. If the device
is not operated for a lengthy period in
installed condition in a damp
environment (e.g. outdoors), it is to be
started up and operated at full speed
for at least three hours once a month to
move the bearings and allow any
condensate that may have ingressed to
evaporate.
In case of further faults, contact ebm-
papst.
Technical safety inspection
What requires checking?
How to
check? Frequency
Protection against accidental
contact/ protective clothing Visual
inspection min. 1/2
yearly
Check product for damage Visual
inspection min. 1/2
yearly
Fixation of product Visual
inspection min. 1/2
yearly
Fixation of wires Visual
inspection min. 1/2
yearly
Insulation of wires Visual
inspection min. 1/2
yearly
Check impeller for
wear/sediments/ corrosion Visual
inspection min. 1/2
yearly