7
E – Air extraction function
By pressing the button “AIR EXTRACTION” the product extracts air from the environment. In case of more units, all
the products extract air simultaneously until new command by the user.
Attention: In this function the sensors are not activated.
Response:
Light pulse on activation of the modality
1 Red / 3sec. / 1 Red
Light pulse modality activated (every 1 min.)
Red
FILTER ALARM RESET
Every 2000 working hours, the device stops running and red light on the right bottom area becomes steady.
Proceed with filter cleaning and reinstall the unit, according to instructions .To reset the hours counter of the
device, follow the buttons sequence to press (refer to image of remote control on page 1)
H1 - H1 - H2 - H2 - H3 - H3
EBERG REQU R+ PRODUCTS CONFIGURATION
This section describes the steps for the wireless configuration of REQU R+ products.
To avoid any communication problems between products that are not part of the same system, it is necessary to set
a unique codification so that products involved only communicate with each other and not with adjacent systems.
To configure the products properly, perform the following steps:
-
Turning On by setting the “0/1” switch.
-
Red and white lights will start pulsing intermittently. This means that the product is waiting for the eight digit
code required to establish a unique network.
-
Enter a casual code of 8 digits between the following: (V5), (S), (H3), (A), (I), (E). During this step, all the
other digits are temporally disabled, hence by pressing them no signal will be given.
-
If the eight digits code is properly entered, the red light will start pulsing while the white one will remain
OFF.
Attention: Enter 8 times the same digit is not permitted. At least one digit must be changed. In case of a
wrong sequence, the red light will remain steady for 3 seconds and after that, red and white lights will start
pulsing intermittently again, waiting for a valid code to be entered.
Attention: Write down the selected sequence in the list at the end of this section. The sequence will be used
to configure all the other products.
While the red light is pulsing, it is necessary to set the product as MASTER* or SLAVE OPPOSITE TO MASTER**
or SLAVE SAME AS MASTER***:
-
To configure product as MASTER, press the (S) button two times.
-
To configure the product as SLAVE OPPOSITE TO MASTER, press the (E) button two times.
-
To configure the product as SLAVE SAME AS MASTER, press the (I) button two times.
-
If the white light pulses two times and after that it turns OFF, the product has been properly configured.
Note: In case of wrong codification of a product or of mode setting, it is possible to use the RESET function
(described in a separate section) and restore factory default settings.
*MASTER: the product controls all the other units in sequence and it’s the only one controllable by using a remote
control.
** SLAVE OPPOSITE TO MASTER: the product is completely controlled by the Master unit. During the Automatic
mode, this product will run in the opposite direction of the Master, hence it will intake air while the Master will run
in extraction and vice versa.
